Page 25 of 25
Re: Wave 16- Oorbellen and Zielbellen
Posted: Sat Apr 16, 2011 1:39 am
by shinkis gonna shink
I keep telling myself my next purchase will be a large armored shinki....I failed...at least she's a tall, my last four shinkis were smalls.
Re: Wave 16- Oorbellen and Zielbellen
Posted: Mon Apr 18, 2011 6:16 am
by Chalkred
persocomsan wrote:I did end up getting both of them.. Orb has extremely loose left hand slot in her arm. Only two of her hands will hold in there very well at all and with the shield attached it's near impossible to move her without it dropping off :/ She's being fitted with some sticky tac for now.
My friend also had this problem, maybe its general to OOR?
ZIEL has no such issues, the shield fits tightly.
ZIEL did arrive with a stuck arm however, and her armor chest piece ruined (doesnt lock at all)
Re: Wave 16- Oorbellen and Zielbellen
Posted: Mon Apr 18, 2011 6:05 pm
by star
Chalkred wrote:persocomsan wrote:I did end up getting both of them.. Orb has extremely loose left hand slot in her arm. Only two of her hands will hold in there very well at all and with the shield attached it's near impossible to move her without it dropping off :/ She's being fitted with some sticky tac for now.
My friend also had this problem, maybe its general to OOR?
ZIEL has no such issues, the shield fits tightly.
ZIEL did arrive with a stuck arm however, and her armor chest piece ruined (doesnt lock at all)
most of my mms 3rds chest pieces dont lock onto them at all either, especially my proxima and maryceles but since it goes around their necks, its perfectly fine and not very noticable unless viewed from the side at an angle
Re: Wave 16- Oorbellen and Zielbellen
Posted: Wed Apr 27, 2011 6:45 pm
by The_Hermit
persocomsan wrote:I did end up getting both of them.. Orb has extremely loose left hand slot in her arm. Only two of her hands will hold in there very well at all and with the shield attached it's near impossible to move her without it dropping off :/ She's being fitted with some sticky tac for now.
Consider the following:
http://gscmikatan.wordpress.com/2011/03 ... ng-joints/
This method worked well for most of my figures. As long as the joint is a peg and a slot, you could just glue a thin layer on to make it fit better.
Re: Wave 16- Oorbellen and Zielbellen
Posted: Thu Apr 28, 2011 7:54 pm
by ZeroEdge
I guess I should consider myself EXTREMELY lucky, 'cause both my fencers don't have ANY faults at all. Well, except maybe the vest-type chest parts, they're not loose, but I do need a bit of effort to fit them properly.
And lucky 2x 'cause I got bookmarks one for each. XD
Re: Wave 16- Oorbellen and Zielbellen
Posted: Fri Apr 29, 2011 5:03 pm
by shinkis gonna shink
I'm enjoying my orbellen very much, kinda dissapointed she's not nearly as pearly as the prototype pics : /
Re: Wave 16- Oorbellen and Zielbellen
Posted: Thu Jul 07, 2011 11:46 am
by trenner dios
Would anyone want to buy these two off me? I really don't want or need either of them any more.